| |
4.2 Installing in an LPAR
-
Verify the hardware requirements. See also “Hardware Requirements” (Chapter “Requirements”, ↑Architecture-Specific Information).
-
Verify the software requirements. See also “Software Requirements” (Chapter “Requirements”, ↑Architecture-Specific Information).
-
Prepare a VNC client for the installation process. See also
“Simple Remote Installation via VNC—Static Network Configuration” (Chapter “Remote Installation”, ↑Installation and Administration).
-
Prepare the system in its firmware or on the i5/OS side:
-
For iSeries, see also “Preparing an Installation on IBM iSeries Models” (Chapter “Preparation”, ↑Architecture-Specific Information)
-
For pSeries p630, p655, p670, and p690, see also “Preparing for Installation on an IBM pSeries Models” (Chapter “Preparation”, ↑Architecture-Specific Information)
-
For eServer i5/p5, System i5/p5, and OpenPower, see also “Preparing for Installation on IBM eServer i5/p5, System i5/p5, and OpenPower Models” (Chapter “Preparation”, ↑Architecture-Specific Information)
-
Configure a client for accessing the system during the installation. See
also “Client for the Operation of the Installation Software” (Chapter “Preparation”, ↑Architecture-Specific Information).
-
For iSeries, set up the IPL source on the i5/OS side and see also
“IPL: Starting the NWSD (WRKCFGSTS *NWS)” (Chapter “Preparation”, ↑Architecture-Specific Information).
-
Install the software and perform the basic network configuration. See also
“Installation with YaST” (↑Installation and Administration).
|
|
