The fundamental purpose of an interactive shell is to read
commands from the user's terminal and create processes to execute the
programs specified by those commands. It can do this using the
fork (see Creating a Process) and exec
(see Executing a File) functions.
A single command may run just one process—but often one command uses
several processes. If you use the `|' operator in a shell command,
you explicitly request several programs in their own processes. But
even if you run just one program, it can use multiple processes
internally. For example, a single compilation command such as `cc
-c foo.c' typically uses four processes (though normally only two at any
given time). If you run make, its job is to run other programs
in separate processes.
The processes belonging to a single command are called a process
group or job. This is so that you can operate on all of them at
once. For example, typing C-c sends the signal SIGINT to
terminate all the processes in the foreground process group.
A session is a larger group of processes. Normally all the
processes that stem from a single login belong to the same session.
Every process belongs to a process group. When a process is created, it
becomes a member of the same process group and session as its parent
process. You can put it in another process group using the
setpgid function, provided the process group belongs to the same
The only way to put a process in a different session is to make it the
initial process of a new session, or a session leader, using the
setsid function. This also puts the session leader into a new
process group, and you can't move it out of that process group again.
Usually, new sessions are created by the system login program, and the
session leader is the process running the user's login shell.
A shell that supports job control must arrange to control which job can
use the terminal at any time. Otherwise there might be multiple jobs
trying to read from the terminal at once, and confusion about which
process should receive the input typed by the user. To prevent this,
the shell must cooperate with the terminal driver using the protocol
described in this chapter.
The shell can give unlimited access to the controlling terminal to only
one process group at a time. This is called the foreground job on
that controlling terminal. Other process groups managed by the shell
that are executing without such access to the terminal are called
If a background job needs to read from its controlling
terminal, it is stopped by the terminal driver; if the
TOSTOP mode is set, likewise for writing. The user can stop
a foreground job by typing the SUSP character (see Special Characters) and a program can stop any job by sending it a
SIGSTOP signal. It's the responsibility of the shell to notice
when jobs stop, to notify the user about them, and to provide mechanisms
for allowing the user to interactively continue stopped jobs and switch
jobs between foreground and background.