Follow Techotopia on Twitter

On-line Guides
All Guides
eBook Store
iOS / Android
Linux for Beginners
Office Productivity
Linux Installation
Linux Security
Linux Utilities
Linux Virtualization
Linux Kernel
System/Network Admin
Scripting Languages
Development Tools
Web Development
GUI Toolkits/Desktop
Mail Systems
Eclipse Documentation

How To Guides
General System Admin
Linux Security
Linux Filesystems
Web Servers
Graphics & Desktop
PC Hardware
Problem Solutions
Privacy Policy




9.6. The /etc/sysctl.conf file

In Red Hat Linux 6.2, many kernel options related to networking security such as dropping packets that come in over interfaces they shouldn't or ignoring ping/broadcasts request, etc. can be set in the new /etc/sysctl.conf file instead of the /etc/rc.d/rc.local file. One important consideration is the IPv4 forwarding parameter which is now done via the sysctl program, as opposed to being controlled by the contents of the file in /etc/sysconfig/network. The sysctl settings are stored in /etc/sysctl.conf, and are loaded at each boot before the /etc/rc.d/rc.local file is loaded. We've already talked about all networking security parameters that we must set into the server in General System Security, and for this reason we'll focus only on the kernel option for IPv4 forwarding.

To enable IPv4 forwarding on your RH 6.2 system, use the following command: Edit the /etc/sysctl.conf file and add the following line:
           # Enable packet forwarding
           net.ipv4.ip_forward = 1
You must restart your network for the change to take effect. The command to restart the network is the following:
           [root@deep] /# /etc/rc.d/init.d/network restart
           Setting network parameters	        [  OK  ]
           Bringing up interface lo	        [  OK  ]
           Bringing up interface eth0	        [  OK  ]
           Bringing up interface eth1	        [  OK  ]

Tip: Enabling IPv4 forwarding via the sysctl.conf file is only valid for Red Hat Linux 6.2 users. Users with version 6.1 of Red Hat must set this parameter into the /etc/sysconfig/network file as explained above.

  Published under the terms of the Open Publication License Design by Interspire